This stuff is able to satisfy requirement af any instrument and any measurement, because it is universal and has no instrument specificity

Scp – is a client to load/unload Sonix+ control modules, check their presence at any time, to ease manipulating of user interface clients and control remote access to the instrument control computer from the Web Sonix site.
More..




Is_client – The script interpreter client is intended to start and stop script interpretation(the measurement procedure), to suspend and resume the measurement procedure, to display the current interpretation status show current operation
More...




Reflector – The Reflector program enables representation of current information about all devices in the system. In a window a tree-like list of devices is drawn, grouped by device type. Clicking on particular device, one can see the complete information about it in a separate window. General device information (state, type, use_flag etc.) is displayed in the upper part of the window. Device specific information is displayed in the lower part as a tree again. Walking along that tree one can find urgent values of particular device parameters. Any device parameter can be included to the “Watch list” for permanent supervision. The contents of these windows is updated automatically.
More...





LogViewer – This program enables to visualize log files. The log file is automatically initialized at the software complex start. It accumulates user, warning, error and info messages concerning both user actions and complex internal affairs. Each type of messages could have level from 1 to 5. The most important is level 1. The LogViewer helps the user to display sorted information concerning either current measurement or previous one. This program also helps the complex designer to understand what have happened in case of complex failures, simplifying a high level debugging.
More...





SpectraViewer is intended for on-line and off-line visualisation of spectra .
More...











ConfigEditor This client is intended for use by instrument responcible and technical staff only. Configuration of the system now is done by a programmer to add new modules to the system and by user to choose device set for the experiment and tune their parameters. All information about the system configuration is stored in a special configuration file. The structure of this file looks like a “tree” were branches represent device related information. Following the tree structure, the user can choose and edit device parameters if necessary. There are also some operations to modify the tree itself (adding new devices, removing unnecessary devices, doubling etc).
More...

Return to GUI